Small Product Photography Setup — Once we’ve been using it for a while and know what we like and don’t like, I’ll tidy away the cables and power supplies. Until then, it’s going to be a bit messy.
Sparkle Zone Storage Center Project
Set up for a quick test — I used a small hand-held fill in light for the test pictures. It has finely adjustable color temperature and brightness.
September 1, 2023 9:35
Sparkle Zone Storage Center, Stage Two, almost complete — Some final adjustments to the bottom doors to be made. There is still some minor work and finishing touches to be completed. Apart from that, all done. +5
August 31, 2023 9:09
A costly mistake… At $70 per door, and I ruined two doors before I realized my error. I forgot to allow for the Inset panel (at 3/16-inch) when selecting screws to mount the doors on cross braces. That brings my ‘Cock-up Account’ up to $200 in a couple of months (don’t ask).
August 30, 2023 9:40
Sparkle Zone Storage Center, Stage One, almost complete. Now for the fiddly bit of the end panel and the ‘fill-in’ panels. That big gap — that’s a special space, and will be Stage Two!
August 26, 2023 17:47
It fits — Carcasses fitted to the wall, this, and fitting the doors is the easy bit.
August 26, 2023 14:06
Will it work? Dry fit. Just eyeballing it to make sure we like the use of space, and checking I hadn’t messed up my size calculations.
August 26, 2023 10:15
Boxes — I was going to custom build the Sparkle Zone Storage Center, but we realized we could save a lot of time (but not $$$ — the doors alone were nearly $700) by bringing in ready-made units.
August 26, 2023 9:58
An empty wall equals storage potential. Recently we’ve been on the lookout for more storage space. We have also been looking for somewhere with space, that we can use for small product photography. The south facing windows of the ‘Sparkle Zone’ offer good light and, we realized, space for storage of our photography gear — and more.